Also trading as:
AMALGEN
BWM
MAGCORE
Dyne Industries Pty Ltd
Dyne Industries Pty Ltd
Dyne Industries Sitemap
Contact Dyne Industries Pty Ltd
You are here:
  • Home
  •  > 
  • DC Power Supplies

Dyne Industries
41 Barry St
Bayswater
Vic 3153 AU

Tel:  +61.397207233
Fax: +61.397207551

Search

Transformers, Power Transformers, Toroids, Current Transformer

24 Volt 20 Amp D.C. Regulated Power Supply

Model 5687

D.C. Regulated Power Supply available as standard in 24 volts 20 amp configuration. Other voltages from 5 to 30 are available on special order.The regulator is temperature limited and time dependant current limited. This power supply incorporates a 'C' Core transformer which gives a low weight and small size compared to a 'E-l' Laminated type.


Specifications
Input Volts: 240 volt 50/60 Hz (110 volt 50/60 Hz available)
Load Regulation: Better than 0.5% no load to full load
Line Regulation: Better than 0.5% for 10% change in input volts
Total Noise: Less than 20mV R.M.S.
Current Limit: 28 amps approx. Output is short circuit protected for models up to 24 volts
Peak output current: Minimum of 40A for 1m second
Meters: 0-30 volts 60 x 70 mm, 0-30 amps 60 x 70 mm
Ambient Range: 0° - 55° Celsius
Weight: 23 Kg
Dimensions: See below

Model Output
Voltage
Output
Current
Input
Voltage
Typical Full Load
Input Current
5687-04
5687-24
24
24
20 Amps
20 Amps
110
240
5.2 Amps
2.8 Amps

Mains Input Variation: The power supply can be used at full output down to an input voltage of 210 Volts, however at low input voltages (below 240 volts) the output ripple will increase if output current exceeds nominal output X [mains input voltage-190]/50. Above 245 Volts the power supply can be used at full rated output however the maximum ambient temperature must be reduced by [mains input voltage-245] x 1 degrees celcius per volt. The input volts should not exceed 255V.

Non-standard Voltages: These power supplies are available for non-standard voltages.